Universel display med relæer og mA output til DIN skinne montage (Intech uP4-Din-R2A)

Vare nr.: uP4-Din-R2A

Universel input og skalering

2 stk. relæ udgange og 1 stk. 4-20mA udgang

Til DIN skinne montage

Fuld programmerbar via USB kabel og uP Configure software (købes separat)

Universel strømforsyning 24~250VAC / 19.5~250VDC

Forsyning til ekstern sensor indbygget

DKK 2.405,00 ekskl. moms

Beskrivelse

The uP4-Din is a DIN rail mount, universal single input indicator, which gives easy interface with a wide range of sensors. It is also fitted with two relay outputs (with two setpoint indicator LEDs), and one optional retransmission analogue output (4~20mA or 0~10Vdc selectable).
The uP4-Din has a 4-digit LED front display, and a universal power supply of 24~250Vac / 19.5~250Vdc.
Setup and calibration is simple, using ‘uP Configure’ software (version 1.5.23 or later), with step-by-step instructions.

Features:

  • Universal Input with Indication.
  • DIN Rail Mount.
  • Universal AC or DC supply 24~250Vac / 19.5~250Vdc.
  • Two Relay Outputs (with Setpoint LEDs).
  • Option to add One Retrans Analogue Output (4~20mA or 0~10Vdc selectable).
  • Programmable via USB Port using uP Configure Programming Software (version 1.5.23 or later) and the XU-USB (Rev 1) key.
  • Simple setup and calibration.
  • 4-digit LED display with Transparent Cover.
  • Sensor power supply for powering external transmitter.
  • Low cost.

Ordering Information:

Code Description
uP4-Din-R2 Universal Input Indicator, DIN rail mount with Two Relay Outputs.
uP4-Din-R2A Universal Input Indicator, DIN rail mount with Two Relay Outputs plus One Analogue Output (4~20mA or 0~10Vdc selectable).

Universal Power Supply of 24~250Vac / 19.5~250Vdc.

 

Note: The uP4-Din Universal Input Indicator is pre-programmed for RTD Pt100 input as standard.

To program the uP4-Din requires the XU-USB (Rev 1) Programming Key:

XU-USB (Rev 1) USB Programming Key for programming uP4-Din using uP Configure Programming Software (version 1.5.23 or later).
Note: XU-USB must be (Rev 1) or later! Older versions will NOT connect with the uP4-Din.(Same Key as used for programming XU Series transmitters2400-A16Z-2400-SleeperZ-2400-A2 Series and IN-uP4.)