Universel display til tavle montage (Intech IN-uP4)

Vare nr.: INuP4

Universel input og skalering

Til panel montage (IP65 tæt fra front)

Fuld programmerbar via USB kabel og uP Configure software (købes separat)

Universel strømforsyning 24~250VAC / 19.5~250VDC

Forsyning til ekstern sensor indbygget

DKK 1.435,00 ekskl. moms

Beskrivelse

The IN-uP4 is a universal single input indicator, which makes interface with a wide range of sensors easy.
The IN-uP4 has a 4-digit LED display. An option to add two relay outputs (with two setpoint indicator LED’s), and one 4~20mA analogue output is available. The indicator (Rev 1) has a Universal Power Supply of 24~250Vac / 19.5~250Vdc.
Setup and calibration is simple, using ‘uP Configure’ software, with step-by-step instructions.

Features:

  • Universal Input with Indication.
  • Panel Mount.
  • Programmable via USB Port using uP Configure software and XU-USB (Rev 1) key.
  • Simple setup and calibration.
  • 4-digit LED Display.
  • Option to add Two Relay Outputs (with two setpoint indicator LED’s), and One 4~20mA Analogue Output.
  • Universal Power Supply of 24~250Vac / 19.5~250Vdc.
  • Sensor Power Supply for powering external Transmitter.
  • IP65.
  • Low Cost.

Ordering Information:

Code Description
IN-uP4 Universal Input Indicator with No Outputs.
IN-uP4X Universal Input Indicator with Two Relay Outputs plus One 4~20mA Analogue Output.

Universal Power Supply of 24~250Vac / 19.5~250Vdc.

 

Note: The IN-uP4 Universal Input Indicator is pre-programmed for RTD Pt100 input as standard.

To program the IN-uP4 requires the XU-USB (Rev 1) Programming Key:

XU-USB (Rev 1) USB Programming Key for programming IN-uP4 using uP Configure Programming Software (version 1.5.7 or later).
Note: XU-USB must be (Rev 1) or later! Older versions will NOT connect with the IN-uP4.(Same Key as used for programming XU Series transmitters, 2400-A16, Z-2400-Sleeper, Z-2400-A2 Series and uP4-Din.)